Pentek Water Dispenser Manual de usuario descargar pdf

Water Filter

Installation and Operating Instructions

Specifications

Tools Required

Screwdriver File Pipe Cutter or Hacksaw

2 Adjustable Wrenches Pencil

Materials Required

Depends on type, size, and location of pipe on which system will be installed. See instructions that relate to your

particular installation, or consult your local hardware store or plumbing supplier to find out more about your particular

installation needs.

Precautions

WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection

before or after the system.

CAUTION: Filter must be protected against freezing, which can cause cracking of the filter and water leakage.

CAUTION: The rubber o-ring provides the water-tight seal between the cap and the bottom of the housing. It is important

that the o-ring be properly seated in the groove below the threads of the housing, or a water leak could occur.

CAUTION: To prevent costly repairs or possible water damage the sump of plastic housings must be replaced every five

years for clear, and ten years for opaque. If sump is older than recommended, replace immediately. Date sump for reference

and indicate replacement date.

• Install on cold water line only.

• Do not install where system will be exposed to direct sunlight.

• Make certain that installation complies with all state and local laws and regulations.

• For prolonged periods of non-use (such as during a vacation), it is recommended that the system be flushed

thoroughly. Let water run for 5–6 minutes before using.

• The filter cartridge has a limited service life. A decrease in water flow indicates that the cartridge should be

replaced.

• Some harmless bacteria will attack cellulose media cartridges. If your cartridge seems to disintegrate or has a musty

or moldy odor, switch to a synthetic media cartridge or consult the cartridge manufacturer.

Filter Housing Temperature Range Pressure Range Optional Accessories

3/4-inch I/O 40–125°F (4.4–51.7°C) 30-125 psi (2.1-8.62 bar) Mounting Bracket (151011)

Spanner Wrench (150295)

1/4, 3/8, 1/2-inch 40–125°F (4.4–51.7°C) 30-125 psi (2.1-8.62 bar) Mounting Bracket (244047)

I/O Spanner Wrench (150539)

1-inch, 1-1/2-inch 40–100°F (4.4–37.8°C) 30-100 psi (2.1-6.89 bar) Mounting Bracket (150062)

I/O Spanner Wrench (150296)

1 2 3 4

Indice de contenidos

Pagina 1 - Water Filter

Water FilterInstallation and Operating InstructionsSpecificationsTools RequiredScrewdriver File Pipe Cutter or Hacksaw2 Adjustable Wrenches PencilMate

Pagina 2 - Whole House Installation

Whole House Installation(1/2 inch or 3/4-inch main cold water line)Materials Required:(2) 3/4-inch or 1/2-inch NPT compression fittingsTeflon®tapeRedu

Pagina 3 - Undersink Installation

Undersink Installation(3/8-inch cold water line)Materials Required:Teflon®tapePlastic tubing(2) 3/8-inch compression fittings(2) 3/8-inch compression

Pagina 4 - Replacement Filter Cartridges

Scale & Coarse Sand, Dirt, Fine sand, Extra-fine sand,rust particles sand silt dirt, silt dirt, siltP5 5 micron nom. Spun Polypropylene 10 gpm/<

Comentarios a estos manuales

Sin comentarios

Pentek Water Dispenser Manual de usuario

Busca en linea o descarga Manual de usuario para Artículos Sanitarios Pentek Water Dispenser. Pentek Water Dispenser User's Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Artículos Sanitarios Pentek Water Dispenser