Pentek RO-3000 Manual de usuario descargar pdf (Pagina 1)

Advanced Reverse Osmosis Water Filtration System

Installation and Operating Instructions

Models RO-3000 and RO-3500 (with electronic TDS monitor)

RO-3000/RO-3500 Operating Specifications YOUR WATER

Pressure Range 40-100 psi (2.8-6.89 bar)

Temperature Range 40-100˚F (4.4-37.8˚C)

Total Dissolved Solids less than 1500 ppm

Maximum Hardness*† 10 gpg (171 mg/l)

Sulfide, Iron and Manganese† less than 0.01 ppm

Chlorine In Water Supply less than 2 ppm

Water Supply pH Limits 4-11

Turbidity 1 NTU Max.

MODEL #:

DATE OF PURCHASE:

* IMPORTANT! If the hardness of your water is above 10 gpg (171mg/L), lime

scale will build up rapidly on the membrane. Scale buildup will plug the

membrane and make the system ineffective. We do not recommend these

reverse osmosis systems be used with water in excess of 10 gpg (171 mg/L)

hardness, unless the water is softened prior to the reverse osmosis system.

† See your local dealer or water treatment specialist to reduce these

substances in your water.

NOTE: If your water pressure and temperature are at the low end of the listed

range (40 psi [2.8 bar] and 40°F [4.4°C]), and the TDS level is near the maximum

(1500 ppm), the system will not function properly. Under these extreme

conditions, pre-warming the supply water using a 25-ft. (7.62 m) coil of tubing

between the saddle valve and the system, and/or installing a booster pump to

increase the water pressure will allow the system to perform effectively.

WARNING: Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or after the

system. Systems certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.

NOTE: Substances reduced are not necessarily in your water. System must be

maintained according to manufacturer's instructions, including replacement of

filter cartridges.

Operating Specifications

IMPORTANT! Before installing this reverse osmosis system, make certain your

water supply complies with the following operating specifications. Failure to do

so may reduce the effectiveness of the system and will void the warranty.

Consult your local water treatment utility or a certified water testing lab to

determine the quality of your water and use the table below to record your

results for future reference.

System Dimensions

System Dimensions 13.75"w x 4.75"d x 12.75"h (349 mm x 121 mm x 318 mm)

System Weight 6.1 lbs. (2.7 kg)

Tank Dimensions 11.3"d x 16.75"h (287 mm x 425 mm) (with valve)

Tank Capacity 1.9–3.2 gal. (7.2–12.1L) (Depending on water pressure)

Tank Weight (full) 40 lbs. (18.2 kg.) (Depending on water pressure)

Production Capabilities

* Tested by NSF International according to NSF/ANSIStandard 58 has given 7.6

gallons per day. Source water test parameters are 50 psig, 77ºF, pH of 7.5 ± 0.5

and 750ppm total dissolved solids.

The RO-3000 is Tested and Certified by NSF International against

NSF/ANSI Standard 58 for the reduction of Total Dissolved Solids,

Fluoride, Turbidity, Lead, Selenium, Copper and Cysts.

The RO-3500 is Tested and Certified by NSF International against

NSF/ANSI Standard 58 for the reduction of Total Dissolved Solids,

Fluoride, Turbidity, Nitrate/Nitrite, Lead, Selenium, Pentavalent

Arsenic, Copper, Cadmium, Hexavalent Chromium, Trivalent

Chromium, Barium, Cysts and Radium 226/228.

• Hand or Electric Drill

(Cordless Recommended)

• Phillips Screwdrivers

• (2) Adjustable Wrenches

• Drill bits: 1/8, 1/4, & 3/8-inch

• File

• Safety Glasses

• Utility knife or tube cutter

• Needle-nose pliers

• Measuring tape

If sink does not have hole for

separate faucet:

• Center Punch

•1

⁄4-Inch Bi-metal or

Carbide-Tipped Hole Saw

• Respirator

Tools and Materials Required

KEEP THIS MANUAL

NOTE: Not all tools may be necessary for

installation. Read installation procedures

before starting to determine if additional

tools are necessary.

1 2 3 4 5 6 ... 15 16

Indice de contenidos

Pagina 1 - KEEP THIS MANUAL

Advanced Reverse Osmosis Water Filtration SystemInstallation and Operating InstructionsModels RO-3000 and RO-3500 (with electronic TDS monitor)RO-3000

Pagina 2 - How Reverse Osmosis Works

Page 10MaintenanceUse only the replacement elements and parts referred to in thismanual. Failing to do so will void your warranty.Replacing the Pre-Fi

Pagina 3 - Replacement Parts

Page 11Questions? Call our Toll Free Technical Support Departmentat 800-861-8758Monday through Friday, 7:30 a.m. to 5:00 p.m. Central Standard Time.Ma

Pagina 4 - Installation

Troubleshooting GuideIf you are experiencing a problem not listed in this manual, shut off the watersupply at the saddle valve, and close the tank val

Pagina 5 - 5. Installing the Drain Clamp

Page 13Performance DataImportant Notice: Read this performance data and compare the capabilities of this system with your actual water treatment needs

Pagina 6

Page 14Performance DataArsenic Fact SheetArsenic (abbreviated As) is found naturally in some well water. Arsenic in waterhas no color, taste or odor.

Pagina 7 - Troubleshooting

Page 15PENTEK ONE YEAR LIMITED WARRANTYPentek warrants to the original owner (under normal use): Reverse Osmosis Systems to be free from defects in ma

Pagina 8 - MATERIALS REQUIRED:

502 Indiana Ave • Sheboygan, WI 53081Toll Free Technical Support: 800-861-8758 • Technical Support: [email protected]

Pagina 9

Page 2General PrecautionsWARNING: The RO-3000 and RO-3500 systems contain a replaceablemembrane critical to the efficiency of the system. Replacement

Pagina 10

Page 3A ROR Replacement Cartridge Kit 155923B ROM-230T Membrane (RO-3000) 155854C ROM-230TN Membrane (RO-3500) 155855D Nitrate/Nitrite Test Kit (RO-35

Pagina 11 - Maintenance continued

Page 41. Installing the Saddle ValveWARNING: Use of a hand drill is recommended. To protect yourself from serious injury orfatal shock when using an e

Pagina 12

AECBDFPage 5A6"5BDC1⁄4”11⁄4”A1⁄4"11⁄4"3Installation Continued2. Selecting the Faucet LocationThe drinking water faucet should be positi

Pagina 13

Page 6B9AC5/8"Installation Continued6. Connecting the Faucet to the DrainNOTE: THIS IS A GRAVITY DRAIN LINE. ANY LOOPS, KINKS OR SHARP BENDS MUST

Pagina 14 - Arsenic Fact Sheet

Page 711AB1012ABrine SealInstallation Continued10. Connecting the Saddle Valve (A) Locate pre-installed white plastic tubing found on the left hand si

Pagina 15 - IOWA RESIDENTS ONLY:

Page 8Installation Continued14. System Startup (Continued)(F) Completely open the saddle valve until it comes to a stop. Allow water to drip from the

Pagina 16 - 146250 12/03

Page 9Testing your Pentek Reverse Osmosis SystemModel RO-3000Reverse Osmosis System1. Total Dissolved Solids (TDS) TestNOTE: Under NSF/ANSIStandard 58

Comentarios a estos manuales

Sin comentarios

Pentek RO-3000 Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Artículos Sanitarios Pentek RO-3000. Pentek RO-3000 User's Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Pentek RO-3000 Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Artículos Sanitarios Pentek RO-3000. Pentek RO-3000 User's Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Artículos Sanitarios Pentek RO-3000